Article Last Updated Decmber 2021
This article is for students who encounter issues when attempting to validate their device or laptop for ExamLock exams. If the steps below do not resolve the issues encountered, please contact the eClass support team by email at email@example.com or by phone at 780-492-9372 as the team may be able to identify specific problems and resolve them. Please note that some devices may not be able to function for ExamLock quiz completion and students should alert their instructors as soon as possible if this occurs and/or attempt to find an alternative device.
Note: If you are currently taking an exam and encounter an issue, first re-launch ExamLock and re-enter the session code that you were given at the start, then click on Resume Exam:
If your issue persists, notify your instructor and contact eClass support.
- Cannot sign-in with CCID when self-serve password resets are not enabled.
Students who have not opted-in to Self-serve CCID password resets are unable to launch ExamLock. The delaying prompt to sign up for this service causes ExamLock to stall and students cannot launch exams. Workaround: follow the link above to sign up for self-serve password resets.
- ExamLock goes black or becomes unresponsive.
This has been reported in Fall 2021 by windows users, often with touchscreen devices but has not yet been fully diagnosed. The black screen issue sometimes resolves itself after a few seconds. If it persists for longer than 2 minutes or ExamLock has frozen and won't accept any input, students can sometimes make ExamLock the active application by cycling through alt-tab until it is selected. If this doesn't work, students will need to restart the application. The problem seems to be caused when a different application forces itself into focus (becomes active) so turning off system notifications in Windows may also prevent the problem.
- "Submitting exam package, please wait..." > "There was an error packaging your exam. Please retry and contact your exam administrator before leaving to complete your submission."
ExamLock is possibly blocked by local software, i.e. antivirus. Disable antivirus or adjust antivirus settings to allow ExamLock to be run. Some Windows users will always see this the first time they attempt to submit after updating ExamLock but the submission will always go through the second time.
- Error at submission "There was a problem uploading your exam package. Please check your internet and try again."
This error occurs if an internet connection issue prevents the complete exam package and evidence from being uploaded. Students should close ExamLock, re-launch the application, re-enter the 5-letter session code, and then select Upload attempt.
- Opens normally but quits after 5 seconds (Windows).
A small number of graphics cards/drivers are incompatible with ExamLock. If the application quits immediately after launching this is the most likely cause - switching to a different video driver can repair the issue. Please contact IST eClass support for troubleshooting steps.
- Error message: "There was a problem with uploading your evidence."
This error can be due to your device time not matching the ExamLock server time. The most common reason for this is if the device clock is out of sync with internet time. To resolve this, ensure that your device is synced to internet time:
Once these settings have been verified on your device, your system time should be synchronized with internet time, and the evidence upload should be successful.
- For Windows:
- Click on the notifications tray in the bottom-right corner of your screen.
- Next, click on All Settings.
- Click on Time & Language.
- On the left-hand side, click on Additional date, time, & regional settings.
- In this new window, click on Set the time and date.
- Next, switch to the Internet Time tab.
- Click on the Change settings... button.
- And finally, ensure that the Synchronize with an internet time server checkbox is checked.
- For Mac:
- Go to your System Preferences.
- Click on Date & Time in the preferences.
- Ensure that the Set date and time automatically checkbox is checked.
- General problems with macOS Catalina